Issue Date: November 14, 1997
Revision Date: December 6, 2002
NON-VOLUMETRIC TANK TIGHTNESS
TEST METHOD (VACUUM)
||Leak rate of 0.1
gph with PD = 100% and PFA = 0%.
||A tank system
should not be declared tight when the acoustic signal detected is
different from the baseline. Baseline is the acoustic signal before tank
aviation fuel, fuel oil #4, waste oil.
volume of 30,000 gallons.
Tank product level must be between 7 and 86 inches.
delivery and testing
||A few minutes to
determine background noise and a leak.
Depends on background noise at the site and on size of leak.
There must be no dispensing or delivery during test.
||Vacuum of 0.5 psi
beyond the vacuum required to overcome the tank bottom pressure must be
maintained in ullage by a vacuum blower.
Net vacuum applied = 0.5 psi + [inches of product level x the specific
gravity of product x 0.036].
is independent of product temperature.
groundwater in tank excavation backfill must be determined.
If groundwater is above the tank bottom, this test system may not be used.
using manifolded tank systems.
Evaluated using diesel. Tests only portion of tank containing
Ullage portion of tank must be tested with an ullage test method.
Microphone was 25 feet away from the leak source during evaluation.
If background noise is too high, test is inconclusive.
Noise signals are tape recorded (not digitally recorded).
Vacuum test method may not be effective in some tank excavation backfill
(such as clay) because it may plug holes in tank.
If soil is saturated with product, air or water ingress may not be
declared by vacuum test. A well point in tank excavation backfill may help
identify presence of this condition.
Ken Wilcox Associates
Manufacturer’s Previously Listed Contact Information is No
Tel: (816) 443-2494
Date of Evaluation: